Discussion Forums > Thalassemia Major
FerriScan : Non-invasive measurement of liver iron concentration
nice friend:
Hi Sahil ,
Edited :
--- Quote --- Does FerriScan measure iron in the liver or in the heart?
FerriScan measures iron concentration in the liver only.
How is FerriScan different from T2*?
Both methods use an MRI machine to gain images of the organ but the technique then applied to those images differ between
FerriScan’s R2 method and the T2* method.
How is FerriScan different from SQUID?
SQUID is a small device which is capable of measuring very small changes in magnetic flux. SQUID machines are extremely expensive
and the equipment is very limited (only 4 exist in the entire world). SQUID machines also require a dedicated technician to operate
them. FerriScan on the other hand is a regulated technique to measure iron concentration non-invasively. FerriScan can be used on
any validated MRI machine in the world and by any radiographer.
--- End quote ---
Note : i have edited complete post ...
Best Regards
Take Care
Umair
Sharmin:
Hi Sahil,
Good to hear from you, it has been a while.
Please see the following site for FAQs on Ferriscan
http://www.resonancehealth.com/resonance/FAQ
My understanding is that Ferriscan is used to measure LIC (liver iron concentration using MRI technology).
The T2* uses MRI technology to measure iron levels in the heart, (myocardial iron deposition) while also measuring heart function in terms of ejection fraction and other measurements.
I think that the Ferriscan and the SQUID test can replace on another (I am not sure!), but the T2* in its focus on the heart cannot be substituted by the SQUID or Ferriscan.
I hope this answers your question.
Sharmin
nice friend:
The test for LIC ( live iron concentration ) is Called R2* and the test measure's the Heart iron is called T2* .. if i m not wrong ...
--- Quote ---With T2*, a bigger score means there is LESS iron in your
heart. With R2, a bigger score means there is MORE iron in
your liver.
--- End quote ---
Edited : And Ferriscan is to perform R2* test ( LIC ) ... And SQUID is to perform T2* test ( test for Heart Iron )....
Take care
Umair
Sharmin:
I find this website to be quite informative:
http://content.resonancehealth.com/000384.pdf
nice friend:
Hi Sahil ,
in India there is only one Hospital have the facility of Ferriscan ... Sharmin is right Ferriscan is only for LIC ( Liver Iron Concentration ) Test .... its not for T2* .. here is the adress oof the center where there is this facility available ...
--- Quote ---1 centre(s) found in Asia, India.
Dr Jankharia's Imaging Centre
Bhaveshwar Vihar 383, S.V.P. Road
Mumbai
Maharashtra 400 004 Asia
Phone: +91 22 66173333 Fax: +91 22 23829595
--- End quote ---
Umair
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version